Building A Spindle Sander For Drill Press

Spindle Sanders is usually essential for sanding curved areas. You can purchase a bunch of different varieties of drum sanders for your transportable drill or your drill press, yet it’s hard to help to keep the sandpaper drums for them within share and the fine sandpaper drums are usually fairly expensive. But there’s another way to build a spindle sander for drill press. Why not build your personal spindle sanders? This particular video demonstrates how:

Whenever curved cut sand marks are found from the band, very good results from a drill press spindle sander. However, unless you possess a spindle sander, you can find additional options with other woodworking tools.

Sanding percussion for spindle sanding is available in different diameters, 3/4 ″ plus 1-1 / 2 with the most readily available among these are cheap and refills are available in different grits like 50, 80 or even 120-grit.

If you are without a devoted spindle sander, a straight forward solution is by using either your drill press or router table to accomplish the working job. In the drill press, the fixed speed can be adjusted at a much slower speed than the adjustable acceleration router but can also do the woodwork. The procedure for building a spindle sander is similar if you choose to utilize your drill press.

How to build a spindle sander for drill press

  • Step 01: To utilize the sanding drum, on a drill press, place the required grit onto the particular drum and tighten up the spindle (following the procedures which come on the drum’s package).
  • Step 02: Then place the spindle into the drill’s chuck and raise the table of the drill press until it is just beneath the particular spindle.
  • Step 03: Start the charged power plus sand your piece, moving the piece contrary to the rotation of the spindle
  • Step 04: Place the particular spindle into the 1/4″ collet and tighten up the collet, ensuring there is at the very least 3/8″ between the underside of the spindle and the very best of the collet.
  • Step 05: Next, adjust the height of your drill press so that the underside of the sanding drum is merely beneath the table’s surface area, with a lot of the sanding drums above the particular table.
  • Step 06: Make sure to set your drill press to the complete lowest speed, which is somewhere between 8,000 -10, 000 RPM. It is a bit quicker than ideal speed; nonetheless, it works fine so long as the stock is kept by you moving. Thus a spindle sander is prepared.

Safety Note

Never try to work with a spindle sander on a new non-variable speed drill press. The 20-25,000 RPMs of an individual speed router is too faster when compared to a spindle sander is made to operate simply.

Leave a Comment

Your email address will not be published. Required fields are marked *